Skip to main content
Start a Conversation

Unsolved

This post is more than 5 years old

alh92

2 Posts

839

September 8th, 2017 11:00

T320 H710 - Windows Server Issues

Hi,

I'm currently trying to set up my T320 with a H710 card.

I have 8 disks currently configured and being detected by the controller, with Windows Server 2016 already installed (along with the other disks having data on them), I have set up 7x Virtual Disks in RAID0 and another SSD as a cachedisk, however it won't boot into Windows (No boot device available) - I have set the SSD with Windows on to be the boot device within the H710 and set the H710 to be a boot device with priorty #1 under Hard Drives C:

I can plug the drives into the onboard SATA controller and they work fine, but not when being pushed through the H710.

Please help!

Thanks

Daniel My

12 Elder

 • 

6.2K Posts

September 8th, 2017 13:00

Hello

I have 8 disks currently configured and being detected by the controller, with Windows Server 2016 already installed (along with the other disks having data on them)
I can plug the drives into the onboard SATA controller and they work fine, but not when being pushed through the H710.

Pass-through and RAID 0 are not the same. If you want these drives to work on the H710 then you need to install the OS after you create the RAID arrays. Disk migration from a pass-through controller or an unsupported RAID controller is not supported. If you want to move data to drives on the H710 then you will need to restore it from backup after you create the virtual disk.

Thanks

Was this post helpful?

View All

No Events found!

Top