T340 Memory Error w/ UDIMMs

Question

I have a T340 with 64gb 2666 UDIMM (4x16GB) with E-2174G and system shows 'Memory Error; an error was detected during memory initialization. Verify DIMMs are properly seated and that they are installed in correct slots.' I was able to get the unit to POST and updated firmware/BIOS by swapping the processor with a Celeron G4930 but when i reinstall the E-2174G the memory error comes back and unit will not POST. I've swapped DIMM slots over and over and drained flea power. I also tried other UDIMMs but the error remains. any insight?

TheMattHatter · Accepted Answer

Yes, the Celeron G4930 recognized all DIMMs. Turned out to be a bad processor. Ordered another E-2174G and the issue was resolved.

DELL-Young E · Answer

Hello, https://dell.to/3SkuL2o Can Intel Celeron G4930 processor recognize all your memories.   I'd also run POST with only one memory on each.

PowerEdge Hardware General

Was this post helpful?