Unsolved
This post is more than 5 years old
2 Posts
0
4780
December 30th, 2013 07:00
T410 boot issue
For some reason, this issue just started happening recently.
We have a T410 running SBS 2011. When it restarts, it displays the IPV4 settings, then it
shows strike F1 Key to continue, F2 to run the system setup program
It stays on this screen until we hit F1, this never use to be the case it use to automatically continue to boot if no keys were pressed,
it no longer does for some reason. appreciate any suggestions, thanks
DELL-Geoff P
990 Posts
0
December 30th, 2013 09:00
Go into the F2 bios and check to see if any unused ports are turned on.. usually, they are the SATA ports that have inadvertantly been turned on when nothing is attached to the port.
Regards,
alongi13
2 Posts
0
December 30th, 2013 10:00
I went into SATA Settings checked the ports they are all off, except for one port which is used for the DVD Drive.