This post is more than 5 years old
2 Posts
1
315374
Dell MD3620i Raid Contoller Module 0 Management IP Error
I get the following error when I try to set the Management IP address of the RAID Controller 0
Return code: Error 4 - The operation cannot complete because of an incorrect parameter in the command sent to the RAID controller module. Please retry the operation. If this message persists, contact your Technical Support Representative.
Operation when error occurred: PROC_setEthernetInterfaceProperties
Regards
DraganK
1 Rookie
1 Rookie
•
36 Posts
2
November 23rd, 2016 02:00
I had a same issue with a few MD3800f. This solution (instructed by DELL support) worked for me.
Configuration:
MD3800f with two controllers with two management ports on each one. IP address on port 1 should be changed (default IP ctrl0 Port1 - 192.168.129.101 and ctrl1 Port1 - 192.168.129.102)
Don't ask me anything about steps :) :)
Step by step:
Hope this will help
mphan
1 Message
0
September 7th, 2017 13:00
This worked for me as well.
Thanks