My church purchased a Dell projector a few months ago to display words to songs and sermon notes. I'm not 100% on the model but can get it if it's relevant. We sometimes have to reboot the computer it's attached to due to software issues, etc. in the middle of the church service. The DELL logo flashes on the screen and it's pretty embarassing. I like dell, but it's weird seeing it pop up in the middle of church! Can someone tell me if there's a way to disable the splash screen or give me a technique to make a computer reboot more "discrete"?
The projector is physically out of reach, but I have full access to the PC and I guess I have access to the projector via the remote I suppose. Wouldn't disconnecting the VGA from the PC pop up the giant DELL logo upon disconnect?
I would like what is displayed during the reboot to be as low profile as possible during the service.
what is the computer and is the splash screen from the computer or the projector? what operating system is the computer running? you can try this if its from the computer.
you can disable the splash screen by making a small change to the Boot.ini file. Follow these steps: Press Windows>>Break to open the System Properties dialog box. On the Advanced tab, click the Settings button in the Startup And Recovery section. In the Startup And Recovery dialog box, select the Edit button in the System Startup section. The Boot.ini file will open in Notepad; locate the line that ends with the /fastdetect switch. Position your cursor right after the parameter, press the spacebar, and add the /SOS switch. Save the Boot.ini file, and close Notepad. Click Cancel to close both the Startup And Recovery dialog box and the System Properties dialog box. Restart the system. When the system restarts, the splash screen will no longer appear. You can observe some of the operations that Windows XP performs during the startup stage. To revive the splash screen, simply repeat the above steps to edit the Boot.ini file and remove the /SOS switch.
This request sounds familiar. In its previous incarnation, I believe the answer to your question is, "No." Short of physically blocking the projected image, there is no way to disable the splash screen.
Let me rephrase my question since it was kind of ambiguous. Sorry about that.
If I unplug a CRT monitor, the screen goes black and the indicator on the monitor changes from green to amber. Of couse it does the same thing when I power down and it does this for a few seconds when I reboot.
If I do any of the above with my dell projector, I get a white splashscreen with the large DELL logo along with some kind of "searching for signal" message.
I am trying to find a way to make the dell projector go black "on demand" via the remote, perhaps, or if there is a setting to make the "searching for signal" screen less intrusive.
I don't know if you can disable the splash screen, but check on the remote for the projector and see if you have a "Freeze" or "Shutter" button on it. The freeze button will just hold the last image projected. I'm not sure if it will keep the image when it looses its signal during a reboot or not. The shutter button will close the shutter in the projector so no light will pass through. This might be a work around to the splash screen issue.