Unsolved
This post is more than 5 years old
11 Posts
0
468
Query RP MDS 9148
Hi,
We will be installing RP 4.1 SP1 along with Fibre connectivity using cisco switch MDS 9148 Firmware ver 5.0(1a) and VNX 5200 Array.To use RP, VNX Array must be installed with recoverpoint spliiter and the existing MDS 9148 firmware will not be any issue as we are not using fabric splitters which is not supported in current version.Is it a support matrix for MDS 9148 firmware?
echolaughmk
522 Posts
0
May 4th, 2015 06:00
Hi,
The version of NX-OS is not dependent on RecoverPoint versions, however if you are looking to validate that the version of MDS code you are running is a supported EMC code using the Connectrix MDS series, your best place to validate would be Elab Navigator and use the advanced query for switches:
https://elabnavigator.emc.com/eln/elnhome
There are target releases for each switch and then other supported releases. From a quikc glance it looks like these are the supported NX-OS versions for a 9148:
The Target releases for the MDS 9148 seem to be this:
Target Releases are the recommended firmware versions to deploy because they are built upon mature and stable code streams with the most recently resolved defects. At this time, this is the list of Target Releases that are only specified for Connectrix C-Series (Cisco) MDS Directors and Switches:
MDS-9148 5.2(8d) or 6.2(5a)
HTH,
-K