Unsolved
This post is more than 5 years old
2 Intern
•
2.1K Posts
•
3 Points
0
4207
December 5th, 2003 10:00
hd tach 2.70 and my benchmarks
just downloaded hd tach 2.70
here are my results-
random access time-12.1 ms
read burst speed-109.6 mg/s
at the bottom of the test results -it reads-
read speed-maximum 85.5 mb/s, minimum 31.4 mb/s, average 50.8mb/s
the test was done on a phsical drive -80gb accordingly to hd tach at the top of the test run-
but the test was actually done on 2-40gb maxtors set up as serial raid 0-
so it looks like my test results are better than a 80gb drive, due to my raid setup
am i correct?
Message Edited by ronss on 12-05-2003 06:59 AM
No Events found!
Francis Nguyen
953 Posts
0
December 5th, 2003 11:00
Yes, but only on the max read speed. You should try to run a real world data transfer from one partition to another partition (same HD). Use a size between 1 and 1.5GB to negate the effect of the HD's built-in cache. You should expect to see a read/write speed around 14 MB/sec.
F.
ronss
2 Intern
•
2.1K Posts
•
3 Points
0
December 6th, 2003 07:00