Unsolved

This post is more than 5 years old

5 Posts

5668

December 23rd, 2005 17:00

problem seeing over 127 GB

I just added a 200 GB internal hard drive to my Dimension 4400. I am running Windows XP service pak 2.  After install and format, it only reads 127 Gb available. I did some researcha nd just updated my BIOS to the .06. How do I get the rest rest of the space? Do I have to reformat it again? Sorry if these are obvious questions, I am just a novice. I did not change the jumpers on the master drive.
 
Thanks in  advance!

6 Operator

 • 

34.2K Posts

December 23rd, 2005 17:00

ejn63 and I certainly appear to be on the same page today.

6 Operator

 • 

34.2K Posts

December 23rd, 2005 17:00

Does your XP disc include SP2? If not, you have two choices. Just partition the unused space (should be available in disk management), or create a slipstreamed SP2 installation disc and reinstall.

11 Legend

 • 

87.5K Posts

 • 

321.3K Points

December 23rd, 2005 17:00

Enable large drive support (see below), open the disc administrator and create a second partition.

If you want a single, large partition, the install CD must be slipstreamed to include SP1 minimum. If you use a pre-SP1 CD to install, the 137G limit applies.

http://www.seagate.com/support/kb/disc/faq/137_winxp.html

5 Posts

December 23rd, 2005 19:00

i went to disk management and i am tryinf to format the unused space as a seperate partition. I tried thia about an hour ago and when finished is stated the the format was unsuccesfull. I am tring again as i type. I will advise. Thanks much!

5 Posts

December 23rd, 2005 20:00

after waiting it says that drive I can not be formatted. I have no idea what is going on. IF I look under disk managemnet it shoes the remaining unavailable space, but I can't use it.

 

 

11 Legend

 • 

87.5K Posts

 • 

321.3K Points

December 23rd, 2005 20:00

Did you enable large drive support first?

5 Posts

December 24th, 2005 03:00

I am looking under disk management and I see my G drive with 128 GB of space and to the right of it I see 58.xx GB of unallocated space. I have tried several times to partition it and format it. Every time after the format is finished it states that it was unsuccessful. 

5 Posts

December 24th, 2005 03:00

I do not know how to enable large drive support..

6 Operator

 • 

34.2K Posts

December 24th, 2005 11:00

See if this helps.

76 Posts

December 25th, 2005 17:00

I might be able to make things easy for you. theres a program call partition Magic 8.0, this will allow you to do what you want it to do.

http://www.soft32.com/download_151.html

Rus

No Events found!

Top