Unsolved
This post is more than 5 years old
5 Practitioner
•
274.2K Posts
0
1037
VMAX 850FX
Hi all
i need to add IP address to the RE ports which are currently showing as offline,
just wondering if this is still binfile change or can i do it by Cli?
array type VMAX850FX
solution enabler v8.2.0.0
i have found the following commands and in the cli guide.
symconfigure set port DirectorNum:PortNum[FlagName = enable | disable]
[, ...] ]
gige primary_ip_address = IPAddress primary_netmask =
IPAddress,default_gateway = IPAddress,
isns_ip_address = IPAddress primary_ipv6_address =
IPAddress,primary_ipv6_prefix=<0-128>,
[fa_loop_id = Integer] [hostname = HostName];
Restriction
This command cannot be used to set port characteristics for iSCSI physical front end
ports and iSCSI target virtual ports. Use the modify iscsi_target on page 271 command.
thanks
taj
KW160
121 Posts
1
February 21st, 2017 07:00
SRDF RE Port IPs can only be changed by BIN file.
That specific command you've referenced can only be used for Front-End iSCSI host ports on older generation VMAXes.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
February 2nd, 2018 08:00
With Solutions Enabler 8.4, is BIN file still required to change IP addresses on RE ports?