Unsolved
This post is more than 5 years old
2 Posts
0
1056
VNXe iSCSI setup with VMware ESX 4.1 not working
I recently setup an iscsi server on a VNXe 3100 system. The IP address 10.0.4.25 I used for the iscsi server belongs to a dedicated subnet 10.0.4 .
I then created a generic iscsi storage and presented it to a ESX host that I had already added to the VNXe hosts. I gave it permissions for "virtual disk and snapshots".
On the ESX side, I setup a vmkernel portgroup with an IP on the same subnet 10.0.4. I then enabled software iscsi and did a dynamic discovery of my vnxe iscsi server, it was able to see it. But when I try to create a new VMware datastore > Disk/LUN otpion, I do not see any targets. I re-scanned the HBA couple of times and I also tried a static discovery by manually adding the target. Still cannot see the LUN to create a VMFS partition on it.
Rebooted the ESX host, no luck.
Both ESX and VNXe and see each other's targets, what am I missing ?
DELL-Leo
Community Manager
Community Manager
•
7.1K Posts
1
October 27th, 2011 23:00
Hi Verman,
In Unispehre, You can click Storage->VMware and create a Virtual Disk(VMFS) storage for your ESX server use. Another operations should be no problem. I think it can solve your issue.
Thank you.
Leo.