Unsolved
This post is more than 5 years old
13 Posts
1
2702
How to enable FE ports on vplex
I have enabled the front end ports of vplex, but when ii check the port status it shows No-Link. Can any one help in letting me know how to enable the ports and assign the wwn's.
Thank you
Andrew-F
27 Posts
0
November 14th, 2012 09:00
No-link means that the port is enabled, but doesn’t have connectivity. This could be because there is no cable plugged in or any number of problems that result in the VPLEX port not seeing a link.
You can do a listing of the sfps context (ls /engines/**/sfps) and check the RxPower column. This context contains information from the port SFP modules. The RxPower numbers should generally be about 300 or more. Ports may work with lower numbers, but you want the numbers to be in the 300+ range. I believe any numbers below the 200 range will cause a dial home.
I have seen where cables aren’t inserted fully or are dirty and it causes problems.
I hope this helps.
Andrew Feldmann
VPLEX Corporate Systems Engineer (CSE)
Data Mobility Business Unit
EMC Corporation
VPLEX on EMC Community Network
Shiva_kv
1 Message
0
August 25th, 2015 08:00
ls /engines/**/sfps only displays the directors, you would need to use : ll /engines/**/sfps --full
~Shiva