Dell Vostro 3350 Win 7
Following a blue screen failure (one month after end of warranty) that could not be resolved I have had a new hard drive installed that is the same model and size as the original. However, when I try and do a factory system restore from the CD I created when I bought the laptop, it won't run - with the error message "not enough disk space".
As I have a blank drive, I do not have any other utilities to fix this. Has the new drive been inappropriately formatted or partitioned? How do I correct the new drive so the system restore will run?
All suggestions gratefully received!
Solved! Go to Solution.
In order to isolate the issue, I would suggest you to run the Pre-Boot System Assessment (PSA / ePSA) Diagnostics. It is just to check the functionality of the hardware installed in the computer. Run the test and check if gives any error code. Note down the error code and update me with the same, would let you know the next course of action.
Please write back with results, would be glad to assist you further.
If a post answers your question, please click "Yes".
Thanks for your offer to assist. The PSA reports no failures. This is what I would expect, as I don't think the problem is 'mechanical'. When the new hard drive was installed, the technician attempted to "clone the entire faulty drive over the top of the new one" in the hope we could run the Dell system restore from the original hidden partition. However, the boot sequence failed when re-starting the laptop.
I suspect the attempt to clone the contents of the old drive to the new drive has created the problem -- a confusion of formatting and/or partitioning that causes the system restore utility to think there's insufficient disk space?
Is there any sense in running a utility to return the new drive to its factory capacity state (e.g. <hddguru.com/software/2007.07.20-HDD-Capacity-Restore-Tool>)?
The stop code is 7B, which I understand means data corruption rather than a mechanical drive failure. However, the data recovery utility we used failed to correct the problem, which is why I replaced the drive (assuming i could use the system restore CD).
0x0000007B ... a very common stop code, that is not limited to "data corruption", can be a driver or controller issue as well, or even caused by malware, etc.:
And that makes it frustrating, as this stop code gives virtually no useful indicators of what might be happening. As the repair utility failed to achieve anything, the alternative was to replace the drive.
Thank you for your suggestions. However, you have not read my original posting correctly. I am not trying to recover the original drive with the blue screen failure. I am trying to resolve a problem with the new drive that will not let my Dell system restore CD run.