Windows system error- IP adrees conflict with another system on network

Go to command prompt and type IPCONFIG /ALL

It shows something like the following:

 

Windows IP Configuration

        Host Name . . . . . . . . . . . . : MyComputer
        Primary Dns Suffix  . . . . . . . :
        Node Type . . . . . . . . . . . . : Unknown
        IP Routing Enabled. . . . . . . . : No
        WINS Proxy Enabled. . . . . . . . : No

Ethernet adapter Local Area Connection:

        Media State . . . . . . . . . . . : Media disconnected
        Description . . . . . . . . . . . : Broadcom 440x 10/100 Integrated Controller
        Physical Address. . . . . . . . . : 09-52-7A-6F-B9-CF

Ethernet adapter Wireless Network Connection:

        Connection-specific DNS Suffix  . :
        Description . . . . . . . . . . . : Linksys Wireless G Network Connection
        Physical Address. . . . . . . . . : 09-42-37-18-50-AC
        Dhcp Enabled. . . . . . . . . . . : Yes
        IP Address. . . . . . . . . . . . : 192.168.1.10
        Subnet Mask . . . . . . . . . . . : 255.255.255.0
        Default Gateway . . . . . . . . . : 192.168.1.1
        DNS Servers . . . . . . . . . . . : 204.12.33.213
        NetBIOS over Tcpip. . . . . . . . : Enabled

 

The bold IP Address is your machine's IP. If you use DHCP (dynamic configuration), type IPCONFIG /RENEW on the command prompt. That should renew your IP. If you do manual IP, find out which machine is using the same IP address. Change it.

wheres the command prompt again

Click on the START button (lower left hand corner)

Click on RUN from the pop up window.

Type your Commands in the little window and there you go!

 

 

 BTW, I'm have the SAME IP address conflict Error show up on my LAN setup. I'm going to try the fix above and see what happens....