Unsolved
This post is more than 5 years old
1 Message
0
2219
Wyse Thin Client X90M7
Hello to all, maybe I can get some help.
I have a Dell Wyse X90M7 thin client laptop, I turned my laptop on and my screen went to the Bios screen and did not load Windows 10.
I have no idea what happened so I went to the support sites to get help and eventually downloaded the firmware tool. I went through the process with the tool I found the right clicks to select what I used to have in my thin client ( I THINK ).
I have a sandisk cruzer 16GB flash drive and after my flash drive had an image on it I plugged it into my thin client and turned it on and nothing was being extracted to my thin client.
I am not a real good Dell Techie but I understand some stuff, but I need help to reimage my thin client.
I hope some one can advise how to do this so I can get my thin client laptop working again.
Thanks to all in advance
Ernest Sauer
RMontalvo
560 Posts
1
November 21st, 2017 09:00
Ernest,
The X90m7 does not have a Windows 10 image, as Windows 10 is not supported on that device.