UNSOLVED
Cisco 9506
Hi there
I have a problem with the Cisco 9506.
Look like there is no communication between blades that run's at 2G and those that run at 4G. They way I have tested this, i have created the following zoning:
HBA ---- 2G
SPA Port 0 --- 2G CX-series
SPB Port 0 --- 2G
SPA Port 0 ---- 4G CX4
SPB Port 0 ----- 4G
I do understand that this is not a supported config. But I don't have enough HBA's plus I am busy migrating Data from the CX to CX4. In the above zone I will be able to see LUN's from the CX series. Can't see any LUN's from the CX4. When I move the HBA to 4G port in the blade where CX4 is connected then I can see LUN's from the CX4. If everything is running at 2G, then I can see all the LUN's from both CX, and CX4. Question is: Is there a setting that I need to change to allow communication between the blades (1/2 and 1/2/4 ports)?
Regards,
T
I have a problem with the Cisco 9506.
Look like there is no communication between blades that run's at 2G and those that run at 4G. They way I have tested this, i have created the following zoning:
HBA ---- 2G
SPA Port 0 --- 2G CX-series
SPB Port 0 --- 2G
SPA Port 0 ---- 4G CX4
SPB Port 0 ----- 4G
I do understand that this is not a supported config. But I don't have enough HBA's plus I am busy migrating Data from the CX to CX4. In the above zone I will be able to see LUN's from the CX series. Can't see any LUN's from the CX4. When I move the HBA to 4G port in the blade where CX4 is connected then I can see LUN's from the CX4. If everything is running at 2G, then I can see all the LUN's from both CX, and CX4. Question is: Is there a setting that I need to change to allow communication between the blades (1/2 and 1/2/4 ports)?
Regards,
T
