Issue, job to re-protect the data didn't run, caught it before it caused an issue.

Would like to monitor drives that don't move from SMARTFAIL to REPLACE status, as I understand that means the data has been re-protected to your selected protection level.

 

I can read the status of every drive from RESTapi. However, from a single poll action I don't know how long the drive has been in SMARTFAIL status. A few hours or days for the reprotect job to run(I think it's the FlexProtect job that is triggered by this?)

 

Is there an easier way to determin that a drive in SMARTFAIL is not being re-protected in a timely manner?