Hi All

Question

When try to running inventry, there is a error message 'destination components is full' what could be the reason?

dpinink_silva · Answer

I would sugest to open the library, review if everything is ok inside, take all the tapes from drives and hands, put them in the slots, and then try the inventory again.

ble1 · Answer

It means that for current operation destination was filled. For example if tape had to be unloaded to slot and tape was there -> you get this error message. Typical example is when customers put new tapes inside library manually and they fill slots occupied by tapes currently loaded in drive. When such tape is unloaded destination slot already has new tape and error message stating destination component is full would be generated.

Hi All

Dell Support Resources

Latest Solutions

Aurora R10 – Request for I-REV BIOS – TPM Attestation Failure – KB 000387773

Would Dell consider providing me with a free PC?

Paid Out-of-Warranty Replacement Parts Request – Precision 5560 Battery & Speakers

Requesting for a free laptop

I'm trying to get perspective with my secure-boot certificate problem