Aurora R11, front fan replacement

You can use zip ties, rubber or machine screws, or a combo of all the above.  And Y split with another pwm header with the lowest load, just don't put more than 2 fans on one header 

@Spencer12219 

As master @r72019 said, zip ties is one way I used...

Pushing zip ties throughUpper front fan in HDD1 + filter + tiesFans, filters, plastic ties, done

This last picture, Y cable to Front Fan header

Pictures?

What noctua fan is that also would this noctua fan work with it

https://www.amazon.com/dp/B00KFCRATC/?coliid=IFX0NC8UR3KFA&colid=2PE0UPXZKEEF2&psc=1&ref_=lv_ov_lig_dp_it

also if I wanted to upgrade my radiator which model would I use if I wanted to upgrade preferably I’d like the exact model/link or the size I would need while keeping the own pump. As I’m kinda new still to upgrading/building computers so I don’t know all the specs or what would be compatible or not

Flashing that EVGA 3080, nice! 

@Spencer12219 

Don't get that fan, it's an industrial noisy fan.

I used this:

Upgrades so far:

• Memory Corsair Vengeance RGB DDR4-3200
• HDD 4 TB WD Blue
• Front Fan Noctua nf-a12x15-pwm-chromax-black-swap
• GPU EVGA RTX 3080 XC3 ULTRA GAMING
• SSD 1 TB Sandisk
• Upper Front Fan Noctua NF A12x25 PWM

---

But it depends, some use ML 120 Pros non RGB/LED some use Noctuas NF A12x15/25 PWM, what Aurora do you have?

R11

@r72019 Flashing that EVGA 3080, nice! 

But master, these are the only memories I have left of my high-thermal days 

Now, I can look at Gandalf and make sure he is doing his job properly thru the looking glass 

Then @Anonymous replied earlier in this thread on the first page

As did the OP, seems ML 120 Pro non RGB/LED is your best chance, just do not get them in a 2-pack.

Just heat I really don’t care if my office room sounds like a server room if anything that’s what I’m going for

Thanks I will just to clarify if I bought the h80i aio along with upgrading the fan to the industrial fan it would work. Also I want to upgrade all fans in the system to that industrial fan so the front fan aswell as an intake fan on the top aswell as the industrial fan in the liquid cooler. Please note I did buy the prebuilt liquid cooled r11

Quick question though would the rad fan in the r11 and h80 aio would I need a three pin or 4 pin connector 

I have been taking a close look at the side panel of my R10, since I was swapping the memory modules out.

I noticed it is double walled, and just going by eye, it looks to me like you could stick a few 120 or even 140 mm fans in there if you take the inside part off and put it all back together.

There's even a handy square slotted channel near the bottom to run the wires in.

I am tempted to try it, but it looks like it will need 20 mm high fans instead of the regular 25 mm high fans.

I can see options here, and 2 fans form the side intake blowing fresh air in would be a nice upgrade.

Any recommendations 

Anybody know how to recalibrate the command center software? Installed a Corsair 120 pro and if I set to 100% in command center it only increases to about 60%. I don’t know if it’s only running at 50% or showing 50%. 
Cheers