3 Posts
0
3501
April 28th, 2021 12:00
Aurora R11, H80i, Pre System Bootup Check Fan Error
I upgrade to a Corsair H80i Liquid cooler which works well. The problem I have is that every time the computer reboots it keeps trying to test the CPU Fan and errors. Obviously I don't have a fan plugged into the CPU Fan port on the board because the pump plugs into the Pump spot. I am running the newest Bios 1.0.5.
What can I do to stop this error?
No Events found!
r72019
8 Professor
•
5.3K Posts
0
April 28th, 2021 12:00
r72019
8 Professor
•
5.3K Posts
0
April 28th, 2021 12:00
Also, clear CMOS
r72019
8 Professor
•
5.3K Posts
0
April 28th, 2021 12:00
Try moving the 4PIN / single sense wire currently connected to the PUMP header over to the CPU FAN header.
Teverz
3 Posts
0
April 28th, 2021 13:00
The R11 has a cmos pins to reset. Do I still follow the instructions you sent?
r72019
8 Professor
•
5.3K Posts
0
April 28th, 2021 14:00
Correct, removing the battery is the same result, just easier.
Teverz
3 Posts
0
April 28th, 2021 21:00
Putting it to the CPU pins worked. Thanks
Arkeys
2 Posts
0
April 1st, 2022 11:00
Hi Teverz, I recently purchased the Corsair h80i version 2 and I'm having an issue finding the port for this USB only cord. Do you know the location to plug it into? Did I buy the wrong water pump?
Vanadiel
8 Professor
•
7.1K Posts
•
29.7K Points
0
April 1st, 2022 12:00
That should go to a USB header on the motherboard, but if I am not mistaken you will not have one available.
Arkeys
2 Posts
0
April 3rd, 2022 02:00
Thanks man! I did some research and it works perfectly fine without that connection.