FA settings for Celerra

Question

Adding a Celerra to get disk from a DMX-4.Does someone know the steps and settings for the FA 's that will see the celerra storage?

dynamox · Accepted Answer

also take a look at these two threads:http://forums.emc.com/forums/thread.jspa?messageID=603554򓖢http://forums.emc.com/forums/thread.jspa?messageID=594836򑎔

dynamox · Answer

what DART version ?

Rainer_EMC · Answer

I would suggest to contact customer service - esp. if this is the first time you are using that DMX for Celerra storage

mcjim · Answer

5-5-31-6

dynamox · Answer

this is what i have on my DMX3/DMX2000SCSI Flags { Negotiate_Reset(N) : Disabled Soft_Reset(S) : Disabled Environ_Set(E) : Disabled HP3000_Mode(B) : Disabled Common_Serial_Number(C) : Disabled Disable_Q_Reset_on_UA(D) : Disabled Sunapee(SCL) : Disabled Siemens(S) : Disabled Sequent(SEQ) : Disabled Avoid_Reset_Broadcast(ARB) : Enabled Server_On_AS400(A4S) : Disabled SCSI_3(SC3) : Disabled SPC2_Protocol_Version(SPC2) : Disabled SCSI_Support1(OS2007) : Disabled } Fibre Specific Flags { Volume_Set_Addressing(V) : Disabled Non_Participating(NP) : Disabled Init_Point_to_Point(PP) : Enabled Unique_WWN(UWN) : Enabled VCM_State(VCM) : Disabled OpenVMS(OVMS) : Disabled AS400(AS4) : Disabled Auto_Negotiate(EAN) : Disabled }

kippy2 · Answer

These links are not working anymore.. any chance of getting an updated link?

Jeffey1 · Answer

Waiting for the updated link.

dynamox · Answer

as an EMC employee/partner you don't have access to Celerra procedure generator ?

Celerra

FA settings for Celerra

Was this post helpful?