4 Posts
0
7055
dell scv3000 setup issues
Has anyone else seen this. When doing the initial configuration with the Dell storage management client, on the Discover and configure iSCSI fault tolerance domains I enter the ip address details and complete the configuration however it gives me the following error and doesn't allow me to continue
Port configuration failed as port at location (controller=Removed by Moderator, slot=1, slotport=3) is not physically connected
All the ports are physically connected and correctly cabled as per specification. Dell support locally has looked at the unit and say there is nothing wrong with the hardware. They have been unable to help us.
Is there perhaps a way to factory reset the unit via command line via the console link?
Please any help will be appreciated.
BrandenG-ZA
4 Posts
0
December 7th, 2018 00:00
DELL-Sam L
Moderator
Moderator
•
6.9K Posts
0
November 28th, 2018 08:00
Hello BrandenG-ZA,
The error that you are getting is stating that the connection from your controllers to your switch the cable is not connected. I would compare your cabling to our deployment guide & make sure that it matches for iSCSI cabling. https://topics-cdn.dell.com/pdf/storage-scv3000_deployment-guide_en-us.pdf
Please let us know if you have any other questions.
DELL-Bob Mi
230 Posts
0
November 28th, 2018 09:00
On this model there is no option to do a factory reset. Looking at your system I show all port connections are down. Are you using the proper Twinax cable to connect the Chelsio 10Gb iSCSI Adapter to the switch? If not then this is why the port connections are not being recognized.
BrandenG-ZA
4 Posts
0
November 29th, 2018 02:00
BrandenG-ZA
4 Posts
0
November 29th, 2018 02:00
In terms of cabling we have completely replaced all the cabling twice and made sure the specification is correct. We have also replaced our storage switches for ones we have in our test environment which we know are working as they run our test system storage. Therefore to the best of our knowledge the physical network is 100% correct.
DELL-Sam L
Moderator
Moderator
•
6.9K Posts
0
December 3rd, 2018 07:00
Hello BrandenG-ZA,
I can confirm with what Dell-Bob Mi stated, that looking at your SC3000 it is showing that all backend connections are showing as down. What color are the lights on your controllers? Since you stated that you already replaced cables & switches with known good from your test environment & all works I am wondering if there are any issues being reported by your switch?
Please let us know if you have any other questions.
shovincyriac
2 Posts
0
March 22nd, 2022 23:00
Hi Branden, may i know how much time it took for the factory reset to complete? we need to oerform a factory reset of dell scv3020 compellent and would like to know the time it will take