Brocade Access gateway and trunking

Question

Hi i use brocade access gateway between  HP blade Brocade 8G  and  DCX 4S edge connectrix. Brocade Access gateway is usefull  for simplify administration but i want more than a simply failover, and  i want a Trunking with F_port on the DCX. it seem trunking is  only possible inside a  contiguous eight ports as one group ? someone  are some experience about this ? thanks                              Pascal

paulaner1 · Answer

I've used the base failover so far and made manual load balance between F-ports (you are getting congestion on uplink?) as you need "PowerPack" license (ISL trunking) for HP/Brocade blade switch? And i think you are looking for F-port masterless trunking configuration

bregs

Paulaner

Connectrix

Was this post helpful?