CISCO Fabric Mgr display question

Question

We are adding HP BladeFrame Switches to our environment via ISLs to our Core switches. When you pull up FM, go to the 'Physical Attributes' frame and select ISLs, we notice that the BFS shows up as the 'From Switch'  while the Core Switch shows up as the 'To Switch' but then the next switch shows up with the core switch as the 'From switch' and the BFS as the 'to switch'.  Is this a timing issue when the ports are initializing or is there a better reason? Thanks

healyj · Accepted Answer

Hi there,

In our efforts to clean up the forum, we came across your question / statement.

If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.

As for now we set it to “answered.”

Regards,

Jim

dynamox · Answer

core and BFS switches are in the same VSAN ?

zippityann · Answer

They do have the same VSANs allocated to the BFS and CORE switches

Connectrix

Was this post helpful?