Before i can start the SAN Copy session we need to create LSAN zones. One of our team member created the lsan zones in the below way.

Source CHA-A

Zone Name :lsan_Cla_3658_spa0_spb0_Cla_0568_spa0_spb0

                  50:06:01:60:39:a0:2a:15 EXIST

                  50:06:01:68:39:a0:2a:15 EXIST

                  50:06:01:60:39:a0:10:d5 Configured

                  50:06:01:68:39:a0:10:d5 Configured

CHA -B

Zone Name :lsan_Cla_3658_spa1_spb1_Cla_0568_spa1_sp1

                   50:06:01:61:39:a0:2a:15 EXIST

                   50:06:01:69:39:a0:2a:15 EXIST

                   50:06:01:61:39:a0:10:d5 Configured

                   50:06:01:69:39:a0:10:d5 Configured

On the Target side also the LSAN Zones were created in the same way. What i observed is the lsan zone information on the source Brocade Router side was propagated to Broaced fabric on the source side but the LSAN Zone info on the target Brocade Router side is not propagated into the target Brocade fabric. Becuase of this i was not able to establish a SAN copy session between two clariion arrays. Can anyone please tell me if the LSAN Zones are configured properly or not.

Brocade Router - 7500