Hi.

Please check if you have access to  these pdf's.

http://powerlink.emc.com/km/live1//en_US/Offering_Technical/Technical_Documentation/300-001-098_A05_elccnt_0.pdf

http://powerlink.emc.com/km/live1//en_US/Offering_Technical/Technical_Documentation/300-001-075_A04_elccnt_0.pdf

Regards,

phukon

Nope, I’m still stuck at the Powerlink “Lite” access level even though I’ve requested normal access.

Thanks,

James

Hi James,

Have you refered to primus emc116045?

It has the details of "how to" access in the powerlink.

Regards

phukon

No, I haven’t seen this on my dashboard at the PowerLink site. Is this a document on the PowerLink site?

Thanks,

James

Still no luck with being able to do anything with this device.  It appears to be a Dell /EMC unit with a model number of DL300.  I've connected a serial cable to the unit while booting, and see that it is an Intel based 800 mHz processor with 1 GB of PC2100 RAM for each of the controllers, but cannot find any configuration mdocumention.

Seems a shame to relagate this to the trash pile when the storage would be great for our test environment.

I finally found an obscure thread on a late night Google safari that made mention of creating a PPP connection to one of the SPs serial ports.  I had been stubmling around with just a normal putty session to the serial port without luck.

Anyway, after creating a PPP connection on that serial port with a username of clarrion and a password of clarrion!, you can then open a web browsers to http://192.168.1.1/setup (for SPA) and configure the default IP address.

Whew, I am now happily working on setting up the unit with our ESXi and Hyper-V servers to migrate our VM storage over to the device.

See my last post for the way to access a unit with an unknown set of IP addresses

Can you please email me these pdfs? I do not seem to have access to them