Unsolved
This post is more than 5 years old
1 Rookie
•
15 Posts
0
1402
April 11th, 2019 22:00
Both eth0 and eth1 on not UP on Same controller
Hi
So far firmware updates are going well on all our machines.
But for one of our SAN, on Active Controller eth0 is UP and eth1 is UP in passive controller. Can we proceed for firmware update?
Thanks
Dinesh Pathapati
No Events found!
dwilliam62
6 Operator
•
1.5K Posts
•
6.4K Points
0
April 11th, 2019 22:00
Hello,
Yes, that's because the active CM is using the port connection on the passive. It's known as "Vertical Failover".
The passive controller can not actually have active Ethernet ports.
You are fine to proceed.
Regards,
Don