Unsolved
This post is more than 5 years old
6 Posts
0
940
October 29th, 2019 16:00
Isilon wipe and reconfig
Hello,
I'm new to Isilon and have a cluster that already has a config on it. We don't care about any of the data (there shouldn't be any). I want to wipe it and start over again so I have the cluster creation wizard when it first boots up.
What is the best way to do that? What commands should I run in the cli? I do have someone on site that can console into it.
Thanks!
No Events found!
Phil.Lam
4 Apprentice
•
638 Posts
•
3 Points
0
November 1st, 2019 10:00
Do you have serial console to nodes? if yes, then run this command per node. If no, then get someone to re-image it.
isi_reformat_node to put it back to factory settings to make or join cluster.
craigschuer
6 Posts
0
November 1st, 2019 15:00
I was able to figure it out. Got a console connection and was able to re-IP it and can use the current config.