Unsolved
This post is more than 5 years old
1 Rookie
•
66 Posts
0
779313
October 26th, 2007 02:00
DECOMPILATION OR DISASSEMBLY PROHIBITED
I have a Dell Dimension 4700. Computer was working fine. I installed a new Seagate 500GB hard drive. I try to boot up and receive this message:
Intel(r) Grantsdale-G PCI Accelerated SVGA BIOS
Build Number: 3329 PC Dev 04/12/2004 17:02:24
DECOMPILATION OR DISASSEMBLY PROHIBITED
Copyright (C) 2000-2003 Intel Corp. All Rights Reserved
I disconnected the new hard drive and tried again, and I get the same message. I am dead. I cannot do anything. I cannot get into the BIOS. Any help would be appreciated.
-- Gary
No Events found!


Hydralisk00222
2 Intern
•
2.4K Posts
0
October 26th, 2007 02:00
ravens515
1 Rookie
•
66 Posts
0
October 26th, 2007 03:00
mombodog
2 Intern
•
12.7K Posts
0
October 26th, 2007 03:00
Open the case and remove the cmos battery for 15 Minutes (note the polarity of the battery before removal) Replace the battery if it is 3-5 years old. Reinsert the battery after 15 Minutes, close the case and plug it in, then do the following before doing anything else.
* Watch the keyboard lights. When they flash, tap the F2 key
* The message, Entering Setup should appear
* Down arrow to Maintenance
* Choose Load Defaults
* Click Continue - Restore factory defaults
ravens515
1 Rookie
•
66 Posts
0
October 26th, 2007 11:00
mombodog
2 Intern
•
12.7K Posts
0
October 26th, 2007 14:00
ravens515
1 Rookie
•
66 Posts
0
October 27th, 2007 14:00
mombodog
2 Intern
•
12.7K Posts
0
October 27th, 2007 15:00
Hydralisk00222
2 Intern
•
2.4K Posts
0
October 27th, 2007 16:00
Bougeault
2 Posts
5
April 13th, 2011 06:00
I had the same problem. It's very easy to repair: Just stop the computer, unplug the power cord, remove all the memory modules from the mother board, start the computer, stop the computer, replace all the memory modules, restart the computer.
Then It should be OK.
fireberd
11 Legend
•
33.4K Posts
•
112.8K Points
0
April 13th, 2011 07:00
There is no use to posting to a 4 year old thread. The only reason I can think of is just to make a post. As you are a new forum member, keep this in mind.
Bougeault
2 Posts
1
April 13th, 2011 15:00
Dear FIREBERD,
Thank you for your message, but it seems inappropriate in this context.
If I read this post, it's because I faced this problem today on my old Dell computer.
If I posted this message, it's because the solution I found was not given, and it may help someone else facing the same problem.
Sincerely.
JayStarr22
4 Posts
0
August 4th, 2011 23:00
Thank you! You just saved my computer from a fate worst than death. The above first salution did not solve the problem, only prolonged the solution. your method plaid out with out a hitch.
Dell Experion gx280 Slim, 3g ram, stock everything else.
speedstep
11 Legend
•
47K Posts
1
August 5th, 2011 10:00
"There is no use to posting to a 4 year old thread."
I disagree. Sometimes you need to float them back to the top to allow someone to get resolution without having to sift thru 4 years or more of posts.
:emotion-4:
garc1970
1 Message
0
August 6th, 2011 07:00
Bougeault, Boy am I glad you decided to update a four year old post, you solution was spot on thanks alot.
Garc
ricjhnstn
1 Message
0
March 3rd, 2012 07:00
Thanks very much for the info Mr Bougeault. I am a complete novice, I didn't even know what a memory module looked like, I had to Google an image of it but I followed your instructions and it is now back in action! Its saved me an expensive trip to the repair shop, Well done!