Device Notification function in new IDT driver is not working.

Is that the IDT driver dated 2-8-13?

If it is buggy I would roll back to the previous version.

The new Feb 8 2013 IDT Driver Seems to be working AOK on my 17r SE 7720,

I only get the Popup when I plug something into the Mic/Line In jack. 

The Headset Jack never popped, but then again it only needs to know if it's a Mic or a Device using Line in.
A headset is a headset.

Hi CyberMaxX360,

I was talking about the headset jack. I never tried the input port. you have also mentioned that headset popup is not showing.

There are some settings in wavemaxx audio which is only enabled if output is a speaker and some other settings which is only enabled for headsets.

However I uesd to use the older driver (most probably A01) which had this notification function working corectly.

Ahhh OK I don't recall mine ever popping up for headsets, not sure what driver my unit shipped with though.  Google is my friend time to do some research I guess.

What where the choices for when you plugged something in to the Headset port?

I see why the other prompts for Mic or Line In.

Cheers

Jim,

yes its 2-8-13 release. I think this is just a repack of the previous one.

I have noticed this problem on the previous release (just before 2-8-13 ) also. this function used to work on the very 1st driver whcih was for windows 7.

What where the choices for when you plugged something in to the Headset port?

I would like to know too. Thanks.

Just a few general observations about the jacks on the 17R SE model. According to my notes there are 2 jacks, a mic jack and a headset (combo) jack.

> The mic jack can be configured for either mic input or stereo line-in, and there should be a pop-up to select between which configuration.

The combo jack is an odd one. It can be used as a regular headphone output jack, or it can be be used as a Smartphone type headset jack, the type where both a mic and a headphones terminate in a single 4 segmented plug.

> When using the combo jack with a smartphone headset it outputs to the headphones of the headset and accepts the input from the mono mic of the headset. Combo jacks cannot be re-configured to be a stereo line-in jack, so there should be no popup to select the input configuration.

> When using it as just a headphone jack, I wouldn't expect to see a popup, but if the original Win 7 IDT driver had that function and it is important to have then maybe that driver can be installed into 8 in compatibility mode. This is the oldest one I can find: 6.10.0.6388, A00

[quote user="CyberMaxX360"]What where the choices for when you plugged something in to the Headset port?

I would like to know too. Thanks.

[/quote]

using A00 IDT driver on win 8