Unsolved
This post is more than 5 years old
2 Posts
0
5328
November 6th, 2005 14:00
installing windows 98 using floppy drive then installing cd
tring to install windows 98 using startup floppy disc then installing cd, but computor does not recognize the cd drive. what should i do?
No Events found!
AussieChris
4.2K Posts
0
November 6th, 2005 18:00
Hi,
If you go to the product suppot tab above, you can find directions. As you dont mention the model I will use general terms. Put the CD drive in the media bay, connect the floppy to the printer port wth the special cable. Load the CD drivers, ( they wont load without the CD being there ) when loaded switch to the CD ( in DOS ) and you can start the load. Some models ( all the later ) will let you select the CD as a boot device, as you are using 98, I am assuming we are talking about an early model.
Regards Chris
Pbx121
2 Posts
0
November 7th, 2005 23:00
AussieChris
4.2K Posts
0
November 8th, 2005 06:00
Hi,
This is the cable