Unsolved
This post is more than 5 years old
1 Message
0
6353
May 5th, 2015 11:00
U2412M, output question
I just picked up this monitor but was hoping to use it for my office procedures. The monitor is not connected to a computer, but DVI out goes to a stryker 1088 digital processor through which a camera for endoscopy procedures is attached. I initially was able to get a picture on the monitor but now, I get the message 'the current input is not supported by the monitor display. Please change input settings etc..'. There is no way for me to change settings since it is not hooked up to a computer. Is there a way around this? Thanks. I have included a picture of the device.
No Events found!
DELL-Chris M
Community Manager
•
56.9K Posts
•
232.1K Points
0
May 5th, 2015 14:00
The default resolution for the U2412M is 1920x1200. That device (according to their manual page 37) is pushing 1280x1024 which the monitor can do, page 6. No idea why it stopped working. Try this =
* Turn the monitor off
* Disconnect all cables from the monitor including the power cable
* Press the monitor power button in for 15 seconds
* Reconnect the monitor cables and re-test