The manual says this “In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged interface from all VLANs, including the Default VLAN, enter INTERFACE mode and use the no switchport command.”
So I think you will need to remove it from all interfaces then add it back to the others.
DELL-Josh Cr
Moderator
•
9.5K Posts
0
March 8th, 2019 09:00
Hi,
Which switch is it? Have you assigned it to another VLAN before removing the default?
MikePatriot
24 Posts
0
March 8th, 2019 10:00
Josh,
It is a S4810 switch.
The interface is currently assigned to the Storage VLAN and VLAN100
MikePatriot
24 Posts
0
March 8th, 2019 11:00
Same result.
Dell Operating System Version: 2.0
Dell Application Software Version: 9.11(2.4)
DELL-Josh Cr
Moderator
•
9.5K Posts
0
March 8th, 2019 11:00
What is the output of show vlan?
DELL-Josh Cr
Moderator
•
9.5K Posts
0
March 8th, 2019 11:00
Try using untagged instead of untag as the command. What version of the software are you using?
MikePatriot
24 Posts
0
March 8th, 2019 12:00
MikePatriot
24 Posts
0
March 8th, 2019 13:00
I've been trying to post the output in table format but it will not post.
Is there a preferred way to post outputs from the console?
DELL-Josh Cr
Moderator
•
9.5K Posts
0
March 8th, 2019 14:00
Can you private message me the service tag and your email address?
MikePatriot
24 Posts
0
March 12th, 2019 06:00
It looks like it finally posted.
MikePatriot
24 Posts
0
March 13th, 2019 05:00
Josh,
Are you able to see my post showing the VLANS?
Thanks,
Mike
DELL-Josh Cr
Moderator
•
9.5K Posts
0
March 13th, 2019 09:00
Yes, it looks like it is there now.
The manual says this “In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged interface from all VLANs, including the Default VLAN, enter INTERFACE mode and use the no switchport command.”
So I think you will need to remove it from all interfaces then add it back to the others.