DELL S5248F-ON

Question

Hi   We have a DELL S5248F-ON running O/S 10 Enterprise. I’m new to DELL switches and for some testing I am using a DELL SFP-1G-T to directly connect my laptop to the switch using ethernet. The switchport configuration is as follows: interface ethernet1/1/6  no shutdown  switchport access vlan 10  mtu 1500  flowcontrol receive off  flowcontrol transmit off  spanning-tree port type edge However, I can’t get the port to come up (it’s currently in an up, down state). I can see that the switch is ok with the SFP. Please can anyone offer any advice? thanks

KerrJ · Accepted Answer

Ah right thank you. The below is the current set up. I'll give that a try

Dell-DylanJ · Answer

Hello,   When you try to bring the port online, what feedback is the switch giving you?

KerrJ · Answer

Hi, The interface shows as up, down. The switch understands the sfp ok with no issues. There is no feedback saying that there is an issue. However I've noticed that port groups are used and the only available speeds to choose for the interfaces are 25Gb or 10Gb. Does the switch support 1Gbps connections ?

DELL-Marco B · Answer

Hello, to connect the 1Gb laptop, the interface must be changed from its native speed of 25 GbE to 10 GbE using the port-group command. The switch auto-negotiates to 1GbE when the laptop is connected.

To verify, can you post the show port-group output command?

Thanks

Marco

DELL-Marco B · Answer

ok thanks let us know if it works. Marco

KerrJ · Answer

thanks Marco - all good

Networking General

Was this post helpful?