This post is more than 5 years old
2 Posts
0
15850
October 30th, 2015 09:00
MLAG CORE + ACCESS STACK
Hello All,
We are replacing our Powerconnect switches with N2048 for the Access Layer and (2) N4032 at the core. I have never used stacking in the past and was hope to manage the members as one. Would it be possible to stack the Access switches and also LAG them to the core for redundancy? The core could be stacked as well, but I'm reading that MLAG is faster for failover.
Should I have a problem with this config?
Thanks for any advice.
Charles
donnellycharles
2 Posts
0
November 1st, 2015 05:00
Thanks for those docs Daniel. I read through them and couldn't find my answer. So the two core switches are stacked together. Then for each Access Switch, also in its own stack, where would I place the LAGs up to the core? How many are required? One from the Master and One from the backup or one from each stack member?