Brocade Silkworm Connectivity

Question

I'm trying to log into our Brocade Silkworm fiber switch through the serial port, but to no avail. Not a bad cable because I can use the same cable to log into our 1855. Here are the hyperterminal settings that I'm using:   Bits per second: 9600 Databits: 8 Parity: None Stop Bits: 1 Flow Control: None   Any suggestions??     Thanks!!!!!

tommo666 · Answer

The 1855 Drac uses a null modem cable and the brocade FC switch uses a straight through. Use the cable that came with the brocade to configure it.

Mtownbound · Answer

The original cable was too short, but found a longer straight through cable. Works perfectly!!! Thanks for the reply, though!!

Networking, Internet, & Bluetooth

Was this post helpful?