To help troubleshoot this problem, on the computer with the problem, go to Start > Run and type cmd then click OK. In the command prompt window that opens, type ipconfig /all then hit the enter key. Write down the output from this command or select it and save it to a txt file, then copy this output into a reply to this message.
Ok, I'm back. I can ping the network(ethernet)interface card -127.0.0.1
Then I uninstalled the NIC card and rebooted....still no good. Below are the
outputs from the ping and ipconfig/all commands:
Microsoft Windows XP [Version 5.1.2600] (C) Copyright 1985-2001 Microsoft Corp.
C:\Documents and Settings\Patrick Lehan>ping 127.0.0.1
Pinging 127.0.0.1 with 32 bytes of data:
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128 Reply from 127.0.0.1: bytes=32 time<1ms TTL=128 Reply from 127.0.0.1: bytes=32 time<1ms TTL=128 Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Ping statistics for 127.0.0.1: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 0ms, Maximum = 0ms, Average = 0ms
C:\Documents and Settings\Patrick Lehan>ipconfig/all
I loaded winsockfix.exe on to the PC and ran it but still the same limited or no connectivity and cannot "renew IP address in the network connections folder.
To try and isolate the problem, try connecting directly to the cable modem. When you change the connection, shut everything off and wait 5 minutes. While you are waiting, unplug the ethernet cable from the modem to the router and plug it into the ethernet port on your computer. Turn on the router and wait another 2 minutes, then turn on the computer and after a minute or so, see if you have a connection. Report back what you find.
After powering every thing down and then with the PC wired directly to the cable modem; power up modem then the PC...still same problem and I noticed that the cable modem has an ethernet light that is NOT lit up when I try to access the internet. Normally it is flashing....
You've got the thread mixed up here by replying to your own posts rather than to my posts.
When connected to direclty either to the cable modem or the router, does the link light come on next to the ethernet port on the computer? If not, then it says that either the network adapter is bad or the cable is bad. Have you tried using a different cable?
Well, since there were no lights blinking on the LAN/NIC card I decided to reseat it before buying a new one. I opened the box and released the plastic bar and noticed that the card didn't look like it was seated all the way into the motherboard socket. Pulled it out, with a static wrist strap on, cleaned the dust off then cleaned the contacts. The video card above looked pretty dusty so I did the same with it and it has a cooling fan that was really dusty.
Plugged everything back in and .....
We are back in business; everything works. I am suspicious of the plastic bar holding the packs (secure)
volcano11
2 Intern
•
28K Posts
0
February 14th, 2008 01:00
To help troubleshoot this problem, on the computer with the problem, go to Start > Run and type cmd then click OK. In the command prompt window that opens, type ipconfig /all then hit the enter key. Write down the output from this command or select it and save it to a txt file, then copy this output into a reply to this message.
Steve
Patindenver
9 Posts
0
February 14th, 2008 12:00
I'm at work now but when I get home this evening I will include that info.
Windows XP Pro SP2
Thanks Steve
volcano11
2 Intern
•
28K Posts
0
February 14th, 2008 22:00
Try downloading and running winsockfix for Windows XP from the Here
Steve
Patindenver
9 Posts
0
February 14th, 2008 22:00
Ok, I'm back. I can ping the network(ethernet)interface card -127.0.0.1
Then I uninstalled the NIC card and rebooted....still no good. Below are the
outputs from the ping and ipconfig/all commands:
Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1985-2001 Microsoft Corp.
C:\Documents and Settings\Patrick Lehan>ping 127.0.0.1
Pinging 127.0.0.1 with 32 bytes of data:
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Ping statistics for 127.0.0.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
C:\Documents and Settings\Patrick Lehan>ipconfig/all
Windows IP Configuration
Host Name . . . . . . . . . . . . : Fi-Dell
Primary Dns Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Hybrid
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No
Ethernet adapter Comcast Hi-speed:
Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : GVC-REALTEK Ethernet 10/100 PCI Adap
ter
Physical Address. . . . . . . . . : 00-C0-A8-8B-93-6D
Dhcp Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
Autoconfiguration IP Address. . . : 169.254.7.165
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :
C:\Documents and Settings\Patrick Lehan>
OH boy I hope I don't have to reload XP...I do have all the disc's.
Patindenver
9 Posts
0
February 14th, 2008 23:00
I loaded winsockfix.exe on to the PC and ran it but still the same limited or no connectivity and cannot "renew IP address in the network connections folder.
volcano11
2 Intern
•
28K Posts
0
February 15th, 2008 00:00
To try and isolate the problem, try connecting directly to the cable modem. When you change the connection, shut everything off and wait 5 minutes. While you are waiting, unplug the ethernet cable from the modem to the router and plug it into the ethernet port on your computer. Turn on the router and wait another 2 minutes, then turn on the computer and after a minute or so, see if you have a connection. Report back what you find.
Steve
Patindenver
9 Posts
0
February 15th, 2008 01:00
After powering every thing down and then with the PC wired directly to the cable modem; power up modem then the PC...still same problem and I noticed that the cable modem has an ethernet light that is NOT lit up when I try to access the internet. Normally it is flashing....
volcano11
2 Intern
•
28K Posts
0
February 15th, 2008 02:00
You've got the thread mixed up here by replying to your own posts rather than to my posts.
When connected to direclty either to the cable modem or the router, does the link light come on next to the ethernet port on the computer? If not, then it says that either the network adapter is bad or the cable is bad. Have you tried using a different cable?
Steve
Patindenver
9 Posts
0
February 15th, 2008 12:00
Sorry, I went back and reviewed Forum Usage 101.
I have changed the 8 conductor cord; no help.
This evening I will verify the light next to the ethernet port...
Thanks again!
Patindenver
9 Posts
0
February 15th, 2008 15:00
Just had my son boot up the PC and the yellow and green LED's are NOT flashing; even while
he is trying to access the internet.
Is a new Ethernet(NIC) card the next step ??
Patindenver
9 Posts
0
February 15th, 2008 16:00
I forgot to say: the yellow and green LED's on the LAN/NIC card are NOT flashing
Patindenver
9 Posts
0
February 15th, 2008 22:00
Plugged everything back in and .....
We are back in business; everything works. I am suspicious of the plastic bar holding the packs (secure)
Thanks Steve!