Dell wireless 2350 router encryption code

From a wired connection to the router, open a web browser and type http://192.168.2.1 into the address bar.   This should load the configuration page on the router.   If you did not change the default username and password, they should both be "admin" (without the quotes).   Go to the security section and see if you can view the encyption code.  If you can't (I don't have the 2350 to be able to check) then you will have to reset the router to its default settings by pressing and holding the reset button on the back of the router.  The default settings change the password back to the default (as above) and disables encyption.  You will then have to log back into the router's configuration page and re-enable encyption, enter a new encryption key, writing it down somewhere this time, and change the encryption key on all affected computers.

 

Steve

Hi,

 

Refer to link http://support.dell.com/support/edocs/network/2350/en/EX_CONFG/set_sec.htm for more info.

 

Rgds

 

Best-Try (Chris)

Steve and Chris,

Thank you for your help!