Symantec Ghost and Optiplex GX270

Question

I am having an issue with trying to ghost an image to a GX270. It has the onboard Intel Pro 1000 MT NIC. When I make the boot disk using the Ghost Boot Wizard, Ive tried the Intel Pro 1000 MT template, ive tried to create my own template using the Intel drivers, and then using the dell drivers direct from the site. I cannot get the nic to bind. I get the following: 'Unable to load using individual node address stored on the adapter A valid address must be provided using the NODE paramater in protocol.ini Failure: Driver did not load , NDIS environment invalid' I have looked at the protocol.ini and there is currently nothing in the node command. How would I find the correct 'individual node address stored on the adapter' and am I even troubleshooting the right direction with this. Any help is appreciated. Jim

Cold_Fulcrum · Answer

I don't use Ghost, as RIS handles this in our network.   I would assume the problem is with the NIC driver and Ghost, but how to resolve this is beyond my knowledge.   This might help, but I really don't know...   http://service1.symantec.com/SUPPORT/ghost.nsf/d87bb6ce0bde286d88256d6a00452701/29196fda697e9ce688256d6b00540c4b?OpenDocument&prod=Symantec%20Ghost&ver=8.x&src=ent&pcode=symghost&dtype=corp&svy=&prev=&miniver=symghost_8

Networking, Internet, & Bluetooth

Was this post helpful?