Unsolved
This post is more than 5 years old
70 Posts
0
995
February 1st, 2017 06:00
Boot bladeswitch into flash commandline using Drac/Cli
I want to reset a password on Cisco 3030 switch in a Dell 1955 Bladecenter and I'm capable of restart the switch and connect before it's booting. But when I want to sent ctrl-break using minicom or screen it doesn't pickup it seems and just boots the switch.
I have tried ctrl+a -> ctrl+b on screen and minicom but I get the feeling that the switch doesn't pick it up. Locally this was no issue in the past, or am I doing something wrong ?
Thanks for any suggestions!
0 events found
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.2K Points
0
February 1st, 2017 07:00
Hi,
Are you able to connect to it with a console cable directly to try it?
YamakasY
70 Posts
0
February 1st, 2017 08:00
Hi,
As I'm remote I'm not able to test that but as I tested that before that works, I just wonder why it doesn't work from Drac.