Unsolved
This post is more than 5 years old
38 Posts
0
1216
Does the SAS6i/R controller support disks larger than 2TB in a non-RAID mode?
If I have a PowerEdge R410 fitted with the SAS6i/R disk controller, can I fit disks larger than 2 terabytes and then either switch the controller to a pass-thru mode or configure each disk as single RAID 0 arrays with one physical disk per VD?
Alternatively, could a H700 controller be fitted in place of the SAS6i/R controller?
Andy
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
March 20th, 2018 11:00
Hello
Please send a private message with your service tag to ensure we have all appropriate information on your system.
Thanks
andyt22imp
38 Posts
0
May 2nd, 2018 23:00
My apologies for the late reply but this was a generic inquiry while planning an upcoming project and did not relate to a specific R410, so I didn't respond with a service tag.
In the end, the project spec was revised and I used R610 servers fitted with H700 controllers, with the disks configured as single RAID 0 volumes.
Andy