Unsolved
This post is more than 5 years old
19 Posts
0
13037
August 4th, 2014 19:00
E000 Intrusion Detection Error
I have a PowerEdge 2850 that had been running fine. I removed the cover to replace the raid battery and it's been giving me an E000 Intrusion Detection Error ever since. I replaced the Riser/SCSI raid board which also has the intrusion detection switch with 2 known good working units and still get the same error. Is there a quick and easy way to fix this issue?
theflash1932
9 Legend
•
16.3K Posts
0
August 4th, 2014 19:00
1. The error takes several seconds to disappear after replacing the cover, many people don't give it enough time for the error to go away.
2. The ESM may not recognize - or may not acknowledge it on the display that the cover has been replaced. This is common with old, out-of-date firmware.
3. Try clearing the ESM/SEL/Hardware Log. It will reset the log and error status and will only then return if the error is persistent.
DonatDonlo
19 Posts
0
August 4th, 2014 20:00
Thanks! I'll try this tomorrow and let you know how it works out.
Don