Skip to main content
Start a Conversation

Solved!

Go to Solution

Douglas Eduardo

1 Rookie

 • 

1 Message

652

November 3rd, 2023 17:23

Erro System Halted - Embedded NIC 1

PT-BR :

Pessoal, boa tarde!


Após uma forte chuva na minha região e desligamento inesperado do servidor, estou passando por este erro ao tentar iniciar novamente o servidor (Modelo PowerEdge T320). Aparentemente indica uma falha em uma das placas de rede onboard (ela está com led verde aceso, até mesmo sem cabo), porém tenho outra placa offboard e outra onboard.  Precisava então talvez desabilitar essa que aparentmente queimou e continuar a usar o servidor.

Não consigo acessar a BIOS e nem fazer nada que esse erro pare de aparecer. Alguem tem alguma dica para me ajudar?

ENG

Guys, good afternoon!

After heavy rain at my region and unexpected server shutdown, I am experiencing this error when trying to start the server again (Model PowerEdge T320). Apparently it indicates a failure in one of the onboard network cards (it has a green LED on, even without a cable), but I have another offboard card and another onboard one. So perhaps I needed to disable the one that apparently burned out and continue using the server.

I can't access the BIOS or do anything to stop this error from appearing. Does anyone have any tips to help me?

DELL-Joey C

Moderator

 • 

4.2K Posts

 • 

31 Points

April 27th, 2026 01:43

Hi,

 

F2 key is the option to access the BIOS. If the system is halted, I don't think you are able to access the BIOS. 

 

Do check where is the PCIe training error is, if it's removable, please remove it and try again. Alternative try these steps:

 

  1. Power the server down.
  2. Disconnect server from all power cables, Network cables.
  3. Hold down the power button continuously for at least 10 s.
  4. Insert power cables and network cables back to the system.
  5. Do not power the server on for initializing iDRAC and wait about 2 minutes.
  6. Press the power button to power the system on.

DELL-Young E

Moderator

 • 

5.4K Posts

 • 

37 Points

November 5th, 2023 23:35

Hello thanks for choosing Dell.

Would this help your understanding?

https://dell.to/40sPDsA
“Embedded NIC1 & NIC2 Allows you to enable or disable Embedded NIC1 & NIC2. By default, the Embedded NIC1 & NIC2 option is set to Enabled”

The point is “embedded”. And you need to get into BIOS first.

Respectfully,

 

Giiuzika

1 Rookie

 • 

2 Posts

April 25th, 2026 19:30

@DELL-Young E​ How do I Force getting into BIOS? 

I've tried to press  F2, F10, F12, Del. But none of them worked, is there any other way?

Was this post helpful?

View All

0 events found

No Events found!

Top