Unsolved
This post is more than 5 years old
9 Posts
0
3600
May 22nd, 2019 00:00
Extending Raid 1
Power Edge T420 with PERC H310 configure in raid 1(2x1TB) since disk is almost full, I'm planning to extend disk 0 by adding 2x2TB drive and configure it to raid 1 and extend disk 0 with the new configure raid 1 drive. Will this work ? or there is a much better way
0 events found
No Events found!
Dell-DylanJ
6 Operator
•
2.9K Posts
0
May 22nd, 2019 06:00
Hello,
You can replace the 1TB drives one at a time, and then extend the array through OpenManage. This is how I would recommend doing it.
theflash1932
11 Legend
•
16.3K Posts
0
May 22nd, 2019 09:00
I didn't follow your original post at all, so I'm not sure if you were suggesting an option or simply asking for one, but you can:
Nemuszxc
9 Posts
0
May 22nd, 2019 19:00
theflash1932
11 Legend
•
16.3K Posts
0
May 22nd, 2019 21:00
Yeah, that was NOT clear from your original post.
Yes, you can add two new drives in a second RAID 1.
"extend disk 0 with the new configure raid 1 drive"
Still unsure what you mean by this … if you add drives in a second RAID 1, then leave them in a RAID 1 as a separate "disk" in the OS. Do NOT attempt to "span" the two disks to create one volume.
Nemuszxc
9 Posts
0
May 22nd, 2019 22:00
by "extend", I mean using the windows Disk management and Extend volume
theflash1932
11 Legend
•
16.3K Posts
0
May 24th, 2019 07:00
Ah, I see … totally fine.
You can extend C:, so long as it is the last (right-most) partition on the disk and the disk is 1) less than 2TB (ending size) OR 2) GPT disk installed in UEFI-enabled system.
Dell-DylanJ
6 Operator
•
2.9K Posts
0
May 24th, 2019 07:00
If it is the C volume, I do not believe Windows will allow the operation. If it is not the C volume, you may be able to extend to another volume.
Most expansions I've assisted with were to grow the RAID from the hardware level, then extend the storage into it.