Since all those other steps have been eliminated, would you confirm if you also waited a couple minutes to power the server up after installing the power cords, which allows the idrac to init before you power the server?
Also, I do see there is a solution listed on the page here.
The fans are controlled by the iDrac, so with the iDrac not working the fans go to full RPM to ensure the server doesn't overheat.
DELL-Chris H
Moderator
•
9.7K Posts
0
February 27th, 2020 12:00
Since all those other steps have been eliminated, would you confirm if you also waited a couple minutes to power the server up after installing the power cords, which allows the idrac to init before you power the server?
Also, I do see there is a solution listed on the page here.
The fans are controlled by the iDrac, so with the iDrac not working the fans go to full RPM to ensure the server doesn't overheat.