Unsolved
This post is more than 5 years old
1 Message
0
6598
February 12th, 2007 22:00
PE2950 12V power connection
I am considering using a PE2950 as a PBX server under Linux using Asterisk. The telephony interface card I am considering requires a 12V molex connector (the same kind used on say, a CD-ROM drive or hard disk).
I looked all around the PE2950 case, and I couldn't find a 12V header anywhere. Does the PE2950 simply not support this? Is there any way to rig up a cable to provide the proper voltage?
In addition, does the PE2950 have a riser card for a 32-bit PCI slot? The only options I see available are a riser with 3 PCIe and a riser with 2 PCI-X Slots and 1 PCIe Slot. If not, then I guess the PE2950 isn't what I am looking for.
I looked all around the PE2950 case, and I couldn't find a 12V header anywhere. Does the PE2950 simply not support this? Is there any way to rig up a cable to provide the proper voltage?
In addition, does the PE2950 have a riser card for a 32-bit PCI slot? The only options I see available are a riser with 3 PCIe and a riser with 2 PCI-X Slots and 1 PCIe Slot. If not, then I guess the PE2950 isn't what I am looking for.
0 events found
No Events found!
Mark_A_Smith
2 Intern
•
827 Posts
0
February 13th, 2007 20:00
hanke
6 Posts
0
May 11th, 2008 17:00
There was a solution for PE2850, which can be found here.
Not sure if it's the same but I'm posting it in case someone needs it. I'm looking to solve this problem in PE 6450.