Unsolved
This post is more than 5 years old
1 Message
0
47086
May 29th, 2012 02:00
Power Edge 2950 Post fail
Dear Sir,
I am using your product Server Power Edge 2950 in network , after main Power supply failure many times then when I tried to restart-up the server again , I got massage on LCD Small screen on front server : Post fail E2022 .
I have tried to turned power-off tiwce and power-up again with out any response , please could you assist me to overcome the problme.
Your response will be highly appricted
Truly Yours,
Ahmed Alhoni
00218 91 326 9544
Email: <ADMIN NOTE: Email id removed per privacy policy>
No Events found!
DELL-Geoff P
990 Posts
0
May 29th, 2012 07:00
Good morning Ahmed,
I am sorry to hear of your E2022 POST Fail issue. You can try the following troubleshooting steps:
1. Reduce the server down to the minimum to POST
a. Power down the server, remove the power cord and hold the power button in to clear the remaining power off the board.
b. Open the case, reduce the memory down to 1 DIMM in Slot 1, disconnect the optical drive, remove the PERC controller, disconnect the drives from the backplane slightly. Remove any other cards. If you have 2 processors, remove the 2nd one. If you have redundant power supplies, disconnect the 2nd unit.
c. Power up the server and observe the LCD display. If it comes up with the E2022 failure message again, power down and swap the processors, and power up again.
d. If the error remains, most likely the motherboard has failed and will need to be replaced.
Regards,