The battery shown below more than likely needs to be reconditioned. This can be achieved from Array Manager or the PERC Bios.

 

Installing the RAID Battery

1. Open the system board tray (see "Opening the System Board Tray").
   
   
2. Hook the front edge of the battery assembly onto the slot in the bay, and then snap the back edge of the battery assembly into place so that the battery lies flat (see Figure 6-21). 

   <ADMIN NOTE: Broken link has been removed from this post by Dell>

Figure 6-21. Installing the RAID Battery

1. Connect the battery cable to the RAID battery connector (RAID_BAT) on the system board (see Figure 6-1).
   
   
2. Close the system board tray (see "Closing the System Board Tray").
   
   

Removing the RAID Battery

1. Open the system board tray (see "Opening the System Board Tray").
   
   
2. Disconnect the battery cable from the RAID battery connector (RAID_BAT) on the system board (see Figure 6-1).
   
   
3. Press the release clip on the RAID battery and lift it straight up to clear the system (see Figure 6-21). 

   <ADMIN NOTE: Broken link has been removed from this post by Dell>

4. If you are replacing a RAID battery, see steps 2 and 3 of the procedure in "Installing the RAID Battery."
   
   
5. Close the system board tray (see "Closing the System Board Tray").
   
   

---

Thank you so much for your help.

 

Jae