Poweredge error messages

CAN ANYBODY GIVE ANY HELP OR GUIDANCE WITH THIS?????

 

I have a Poweredge 2550 that was running Windows 2000 (and has been running fine for a while), that I was going to upgrade to Windows 2003.  I opened up the machine to check the memory config and after verifying that I was using all 4 slots closed the machine up.   After that the  drives (scsi) could no longer be seen, also in the POST boot I do not have the option to go into the Scsi Select....  (I have checked and double-checked all the physical connections in the box to make sure I didn't accidently disconnect a cable, I did not.

 

On POST boot I get the following error message/warnings:

 

Invalid NVRAM configuration, Resource Re-allocated (I get this every time) (f1 to continue, f2 for setup)

No Boot device available (every time) (f1 to continue, f2 for setup), obviously I cannot continue.

 

I am running:

 BIOS version A09 (re-applied today)

 ESM firmware 5.5

 Primary backplan Controller 1.32 (upgraded from 1.3 today to attempt to fix the problem)

 

When I run the Dell Diagnostics I get the following errors on the ESM:

 

Test Errors
Embedded Server Mgmt - ESM2 System Board Sensor Check      : Fail
  Status: Fail  Status Code: DOS DDG-D ESM2 030 036
  Device: Embedded_Server_Mgmt  Test: ESM2_System_Board_Sensor_Check
  Release: 1081 Module(s): Esm2
  Msg: An important event was detected in the ESM log. Critical error on entry
89 of 97.  SMB event was reported for MB Voltage Battery sensor with a value of
0077h.

Embedded Server Mgmt - ESM2 PSDB Test                      : Fail
  Status: Fail  Status Code: DOS DDG-D ESM2 120 036
  Device: Embedded_Server_Mgmt  Test: ESM2_PSDB_Test
  Release: 1081 Module(s): Esm2  Msg: An important event was detected in the ESM log. Critical error on entry
89 of 97.  SMB event was reported for MB Voltage Battery sensor with a value of 0077h.

 

 

Any help/guidance would be appreciated.

 

 

Jim Cain

Fastheat