Unsolved
This post is more than 5 years old
1 Message
0
1422
October 20th, 2017 07:00
Server OOW PowerEdgeT420 - Non-Critical Error
After recently replacing a Physical Disk on a Connector 0 (RAID), the disk is now online and spun up however we are still seeing a Non-Critical error appearing on the following component within Dell OMSA: Enclosure (Backplane).
We have already cleared the logs to rule out any old alerts, however the severity alert of a non-critical alert is still appearing yet if we click "Enclosure (Backplane)", the next section, Physical Disks shows a status of OK.
- Does anyone have any ideas why this Non-Critical alert can be appearing?
0 events found
No Events found!
Daniel My
12 Elder
•
6.2K Posts
0
October 20th, 2017 10:00
Hello
It could just be an issue of OMSA not properly updating the status after the drive replacement. If the status persists after the rebuild is complete then restart the OMSA services. If that does not clear the status then it may persist until a system restart.
You should also check to make sure OMSA doesn't have a driver or firmware update listed as required. If a driver or firmware update is available for a backplane or controller it will produce warning messages in OMSA.
Thanks