Start up trouble; please help!!!

Dear sir,

    

        Here is my situation.  During setup the network to all computer, I accidently fill in IP address to PE1850 same to another computer in the network. Then everytime I start up this PE1850, BIOS will show up this massage.

 

                                                                                                                                           F2 = Setup

                                                                                                                                 F10 = Utility Mode

                                                                                                                                   F12 = PXE Boot

Two 3.6 GHz Processors , Processor Bus: 800 MHz, L2 Cache: 1 MB

 

Remote Access Controller detect

 

LSI Logic Corp. MPT BIOS

 

Copyright 1995-2004 LSI Logic Corp.

 

MPTBIOS - 5.06.06

 

Spinning up the device! HBA 0 , ID  0 , LUN 0

 

Spinning up the device! HBA 0 , ID  1 , LUN 0

 

Searching for device at HBA 0 , ID  0 , LUN 0

 

Drive 0 on adapter 0 is predicting a future failure. The sense qualifer is 00h

 

Press any key to continue.....

 

 

                Any way I could solve this trouble? Any answer are greatly appreciate.

 

                                                                                                                 Best regard

 

                                                                                                                   Nooknik